2
« on: February 04, 2018, 09:12:17 am »
Hi, I am new both to Tweak and to this forum.
I ran tweak for the first time today. I used safe mode and followed all the instructions with care. 45 problems were identified and the repair process began. When it got to number eight it stayed there for three hours before I dared to do anything.
Read and write both showed zero and it had used 1.5 Gb. The cpu was showing between 1.2 and 1.8 mostly.
Since it was obviously frozen in that I could not get a response to mouse clicks anywhere I had to switch of the mains power to shut down. The PC restarted ok but with lots of aps and setting reset to default.
I am running Win 10 (64) with an AMD A6-6310 APU Processor. Any advice would be most welcome.
Regards,
Jeff.