Messages

1

Tweaking.com Support & Help / Re: I get an invalid picture when in safe mode

« on: March 17, 2016, 07:42:06 pm »

Thanks, that is good info to know. I have an old external SATA 2 i can use, a little slow but better than what might happen. I did not know it booted to fast. I'm not sure I will upgrade but if I do I want a new MB and secondary SSD in it first. I build it & made a system repair disk. Trying to learn win 10 may go to the back burner before the free version expires. Thanks again.

2

Tweaking.com Support & Help / Re: I get an invalid picture when in safe mode

« on: March 17, 2016, 05:20:11 pm »

Yes invalid image still showed in safe mode. It seems to run well but has a minor quirk or two. It is set to back up every week and I believe there is a system image there. I'll check it out. I thought of upgrading to win 10 without any issues. Thanks

3

Tweaking.com Support & Help / Re: I get an invalid picture when in safe mode

« on: March 17, 2016, 04:53:16 pm »

I deleted the icon and did as suggested. It appears to run fine and did before but I never tried the repair part. It says its best to run that in safe mode. I know some programs that may interfere  & I do not want to take a chance. I know there is a backup but I'd prefer to feel safe at this time. Maybe later on but not now.  Thanks

4

Tweaking.com Support & Help / Re: I get an invalid picture when in safe mode

« on: March 16, 2016, 12:12:48 am »

Yes as mentioned I did that before I posted. However I did it again with no integrity violations. I also booted into safe mode 3 or 4 times. There is a definite problem. Its seems kind of strange that only a few get this message.  Thanks for your time

5

Tweaking.com Support & Help / I get an invalid picture when in safe mode

« on: March 15, 2016, 04:07:51 pm »

I followed directions, did a power reset then some optional repairs, SFC - ck disk plus a back up & sys restore. Then booted in safe mode with networking on a Windows 7 computer. What happens is I get an invalid picture message with and X in a red circle. The program does not load in safe mode. I tried it from the shortcut and start menu. I could have taken a screen shot but its the same that has happened before. I planned to take the free version for a test drive then consider the pro. Hopefully it can be resolved, if not no point in going any farther. Thanks for your help