System Protection - error 0x80070005

[Clade]

Good morning everyone!

Remembering that my language is not English. . . which may hinder a little communication.

Dell Inspiron N4050, Windows 7-64, Home basic.

Initially "C" (system), increased from one moment to another, the volume.

Observed that it was one of the restore points, which used no less than 30 GB, only he, and all together, used 90 GB. After that point and excluded from some other "C" has returned to normal.

Observed protection system that it found itself changed, using configuration, approximately 98 GB, because usually, I leave an 8 GB for restore points.

The system creates the restore point, changes the amount of GB available, but when I try to use the "apply", have the following information:

"Could not create the scheduled task for the following reason: Access is denied 0x80070005" and unexpected error in the property page

Deactivating and reactivating system protection, same error. Make changes, but it has this error.

Used Combofix, Malwaribytes and other good scanners but nothing relevant was found. . . imaginos then it is not difficult for malware.

Was also used SFC, CHKDSK C: f / r /.

Please positioning.

[Clade]

Complementing information.

Roguekiller found Pum. policies (attached)

The equipment gives the normal boot, but looking msconfig, "System Startup" tab, I have no access to system startup does not have access to any of the options. (attached)

In the "General" tab, access the options is normal, but in an attempt to "apply" has the following information:. "System configuration can not save the original boot configuration for later restoration Changes in The startup will be reversed. device is not ready "

[Boggin]

If the actions of this PUM are recent, boot up into Safe Mode and try your restore points to prior the infection.

[Clade]

There are no restore points, only one, created as a test, when equipment has had difficulty.

Nor is it incompatible antivirus, uninstalled it and nothing has changed.

[Shane]

First thing to do is to check the drive for bad sectors. Always the first thing because sometimes it is the cause and not an infection. Then if the drive is good then try running my windows repair and run all the repairs.

To do a bad sector check open a cmd.exe window and put in
chkdsk c: /r

It way say the drive is in use and would you like to schedule it for next boot, hit Y

Now reboot and it should do the scan, it will take a while. You can see the results in the event viewer afterwards. If the drive is good then try my WR and let me know how it goes

Shane

[Clade]

Equipment running well. Super fast ..

Already tested .. chkdsk.

I tried all the available backups Registry Tweaking the oldest of 29.08 and nothing changed in the protection system.

In the last restart msconfig returned to work.

[Shane]

Did you run all the repairs in the Windows Repair tool?

Shane

[Clade]

I managed to resolve the difficulty by using the same procedure for cases where it was not possible to create a restore point: Catastrophic Failure 0x8000FFFF Error When Trying to Use MS Backup. The equipment in question I could create the restore point, unlike the solution presented.

The difficulty concerned the protection configuration of the system, not creating restore points.

solution:

1 Start:

2 type "services";

3 Scroll down the list of services and double-click the Volume Shadow Copy service.

4 Select Manual from the Startup Type field if it is not already selected.

5 Click the Start button under Service Status

6 Click OK and close the services window.

7 Try to reconfigure the system protection.

See attachment:

NOTE: Remember that if the service is manual, you can change to another starting and then returning again to manual.

In this case, the object of this post, even adopting the procedure, another error appeared, but I was clicking OK, OK, and everything was working. Even rebooting and everything working.

Well, well, well, these are things of the Windows OS.

Remembering that I have OS images, but this gives me the assurance to try other solutions.

[Shane]

Was vss disabled? And all it took was enabling it?

I never understood why, if MS has so many of their tools require other services, why they dont ever have the tools set to reenable a service if it is needed, or at least ask the user lol

Shane

[Clade]

Did not quite understand what happened, because I was creating restore points without any error, it can be assumed that the VSS was working.

Today, I tested again, and everything is working fine.

As I like to read and participate in various forums in the area of ​​Windows OS, I see lots of complaints from users, many unanswered questions and so many answers that do not resolve the inconsistency. . . One gets the impression that Microsoft is not too worried about them.

[Shane]

MS has to many fingers in the pie is the problem. I remember reading on XP there was over 10,000+ programmers. On the start menu and task bar alone had 110 programmers. So you can see why it can be a pain to find out information even for them, to many damn people lol

Shane

[Clade]

Makes sense

Interesting that there is software like yours, that make life easier for many users of Windows OS.